Safety instructions for the use of pallet stretch wrapping machine

Safety instructions for the use of pallet stretch wrapping machine

Safety instructions for the use of pallet stretch wrapping machine

Recently, we often hears from customers asking questions like this: Will there be any harm to the human body if using the pallet stretch wrapping machine for a long time? When we heard this question, we thought it was funny. This is not a high-radiation device, so how can it be dangerous? But think about it carefully, in fact, what users care about is whether there will be any danger in the process of using the pallet stretch wrapping machine, after all, the turntable of the pallet stretch wrapper runs at high speed. In response to this problem, we will introduce you to the safety instructions for the use of the pallet stretch wrapping machine:

1. When the machine is operating, people should be a certain safe distance away from the turntable. After the machine stops, move closer to the machine, remove the goods, turn off the switch, and cut off the power supply. This is the first thing to do when using a pallet stretch wrapping machine, especially when the goods are slightly larger than the turntable of the pallet stretch wrapping machine.

2. It is strictly forbidden to reach inward or reach into other objects to prevent damage to the rubber roller or fingers. This is something you should pay attention to when using any machine. When the machine is running, you must not extend any part of your body into the machine.

3. The power supply voltage cannot exceed the voltage required by the machine itself, so as not to burn the machine.

4. When the machine is in normal use, regularly check whether each connecting part of the machine is moving or falling off, if any, be sure to tighten it.

5. It is strictly forbidden to move or remove the upper and lower fixed limit blocks.

6. In order to prevent the bulk cargo from hurting people and the machine tipping over, safety fences must be installed when necessary.

7. It should be firmly grounded or connected to zero (zero ground should not be mixed) to prevent leakage of electricity from damaging the machine or personnel. Circuit incidents are not trivial. Once a problem occurs, it will be a major incident. Therefore, you must be extra careful with electricity safety.

Leave a Reply

Your email address will not be published. Required fields are marked *